Quick Question!

Have you ever purchased from PartSelect.com before?

11757609-1-S-Whirlpool-WPY913079-Heating Element O-Ring
11757609-1-S-Whirlpool-WPY913079-Heating Element O-Ring http://www.partselect.com/Schematics/Maytag/53702.gif

Heating Element O-Ring

PartSelect Number PS11757609

This heating element o-ring is less than an inch in diameter. It is all black in color and is made of rubber.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Not drying dishes properly.
  • Leaking.

Compare At

$6.18

You Save

$1.03

Your Price

$5.15
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.3 / 5.0, 1 reviews What's this?
1-1 of 1
 

25 of 28 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 1- 2 hours
Tools: Pliers, Screw drivers, Wrench (Adjustable)
Customer: J from San Antonio, TX

Replaced drying heater element due to lime scale build up.

1) Turn off water
2) Place receptacle to catch water before removing water fitting.
3) Disconnect water tube from valve.
4) Remove screws from mounting skirt connecting washer to counter/woodwork.
5) Slide washer out of slot paying attention to water tubing and electrical wiring. Ours was installed in such a manner to allow removal of water tube with a little flexing. Wiring as a simple 110 plug so simply unplugged.
6) Tilt washer onto back.
7) Connections for element will be close to floor one washer on back.
8) Gently pull electrical connections from heater element to remove.
9) Remove nuts holding element in place.
10) Tilt washer upright. (May require second person here to help balance washer)
11) Open door and remove heater element. There are two clips holding to bottom that require a little dexterity to navigate.
12) At this point simply reverse the above instructions to reinstall. The insulation around the housing was a little tricky to navigate while sliding the washer back into place. It has a tendency to hang up on the woodwork.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1