Quick Question!

Have you ever purchased from PartSelect.com before?

11757547-1-S-Whirlpool-WPY314137-Rubber Leveling Leg Foot Pad
11757547-1-S-Whirlpool-WPY314137-Rubber Leveling Leg Foot Pad 11757547-2-S-Whirlpool-WPY314137-Rubber Leveling Leg Foot Pad 11757547-3-S-Whirlpool-WPY314137-Rubber Leveling Leg Foot Pad http://www.partselect.com/Schematics/Maytag/36051.gif

Rubber Leveling Leg Foot Pad

PartSelect Number PS11757547

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$4.82

You Save

$.80

Your Price

$4.02
Order within the next 8 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

1 of 2 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: GERALD from ALBUQUERQUE, NM

Broken belt

Followed the instructions supplied with parts. My wife was so happy and the repairs were easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 3 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Pliers
Customer: Dennis from Granada Hills, CA

Warn out foot pads

Pried off old pads - used hammer to tap on new pads.

Locating replacement parts was the problem until I found partselect.com

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 2 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Screw drivers
Customer: Coyote Custom Builders from Phelan, CA

Belt was hard and made a squeaking nosie, rubber pads were o good because of age.

First I disconnect the electrical power, 2nd disconnect the vent tube, 3rd removed the four screws on the back of the dryer, 4th removed the front panel and disconnect the wires for the door switch, 5th remove the cover that holds the drum inplace, 6th remove the belt, 7th vacum all parts to remove any lint and dirt from the inside of dryer, 8th reassemble the parts in the reverse order. this took me about 55 minutes from start to finish. The parts were right which made the job very easy. The rubber foot pads were easy, just remove the old ones and install the new ones. Thank you for the right parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-3 of 3