Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11757475
This electric oven bake element with screw in wire terminals is 19 inches wide. It has a terminal depth of three inches and a total element length of nineteen inches. This element is intended for use with some electric ovens.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
unscrewed 2 screws holding element to back of oven, disconnected connectors from element, connected new element, replaced the screws and done. if you don't trust oven controls then unplug oven/switch off circuit breaker first.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed old element by removing screws from plate and removing old wires. Had to get conversion from electric store as new element was screw in and the old one was hard wired. Stripped old wires and placed on converters. Screwed the electric converter parts to the element. Screwed into oven wall.
The replacement part received had the exact electrical and mechanical interfaces as the original element so installation was simple.
This repair was so eazy my 18 old son repaired it.
It was difficult to take out the burned out part, because it was in for so long, but WD 40 helped take it out. First I unscrewed the two screws, then pulled the element out enough, so I could disconnect the wires. finelly I took the element out, put in the new one and did the same thing backwards, i.e. attached the wires, screwed in the two screws, then I tested it, and when I saw it worked, it was done.
It was easy. Just remove the two screws, gently pull the housing out, remove the two wiring clips, and then reverse the process with the replacement.
My Neighbor took about 5 min to put the new part in place. very easy!!!one screw was tough to remove but that was the hard part. It was very simple to do.
Took the old one out (screws); put the new on in!
First I shut off the breaker that supplied power to the range. After removing the oven racks, I undid the two screws that hold the element in place. Then, I gently pulled the element out of the back wall of the over and removed the two clamps holding the wires in place. I put the new element in place, applied the wires, pushed it back into place, and replaced the screws. Last, I turned the circuit breaker back on and checked to make sure the oven heated up. Total time was less than 15 minutes.
This is what people need to know. Unit burned out 7:00pm Thursday, ordered the parts 11:00am Friday, FedEx delivered it to me Saturday at 1:00pm. How can anybody ask for more. Good price and easy to install. Julia W
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.