Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11757437
This high pressure inlet hose washer is black. It is an inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
tilted the dishwasher back so the bottom was exposed and unhooked the old hoses, then removed old hoses through the back side of the dish washer then fed the new hoses through the back and hooked them up.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed washer top by depressing spring loaded clamps with a screw driver. Tricky part was determining location of clamps so that I knew where to insert screw driver; (I used diagrams of my model found on the Internet). With top lifted up, I located water control valve and removed brackets and plastic fixture surrounding it. Was careful to disconnect electronic wiring into valve. Then removed hoses and replaced with new part. Most of the time spent was diagnosing problem, determining plan for getting access to part, and reassembling without losing parts down in tub area. Saved an estimated $150-250 by doing it myself.
When selecting a cold cycle, the inlet valve would allow for slow water flow resulting in 15+ minute tank fill times. I unplugged the washer, disconnected all water sources.I removed the 3 screws holding the water inlet value and cover. Disconnected all cabling and water tubing. Replaced valve, reconnected all cabling and reinstalled.While I was doing the repair on the inlet value. I replaced the hose washer and also installed a screen kit at the home water valve. The home is supported by a well and at times sees sedimentation in the water which could have sparked the initial issue to begin with.I did clean the old water inlet valve once before which fixed the problem temporarily. It was time to replace the entire part.This corrected the issue.
I removed the one screw on the plate which exposes the water inlet lines. Disconnected the two leads to the inlet valve.Replaced the defective inlet valve and re-connected the leads. Replaced the plate coveringthe new inlet valve. Done.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.