Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11752537
This bake element for your oven, range, or stove provides heat from the bottom of the appliance to cook or bake your food items. You may need to replace this part if your oven is not heating properly. This bake element is approximately 22 inches wide. Disconnect power to your appliance before completing the repair because you will be working near electrical wiring harnesses. The wiring harnesses feature slip-on terminals for easy installation. Be sure to hold the wiring harness forward so they do not fall behind the panel, as they are difficult to retrieve. This is an authentic OEM bake element.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
turned off breaker for oven,opened door, removed racks,removed two screws,pulled out the element, dis connected wires,reconnected new element,put back screws,replaced racks,turned breaker on,perfect fit.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed 2 screws securing bake element, pulled element clear with wires still attached, then removed the wire push terminals. Attached terminals to new bake element and reinstalled. Extremely simple.
When I removed the bottom bake element and tested it with an ohm meter, it was an open circuit. Once the new one arrived, I simply had to hook up the two leads, screw the cover back on the back of the oven and the job was done.
when I removed the element I notice that the terminal of the two wires they were verticale and the old part were about 15 degree upright, so I used player to bend the angle. it is working .Also let me say Part Select has wanderful service by phone and fast deliver.
I removed two screws holding the element in place. Carefully pulled the element from its mounting throught insulation to expose the two wires connected by electric wire clips. I removed the clips and searched the part online using google. Part Select was provided as the top source. I ordered the part and it was delivered in two days. Taking care to thread the connection through the insulation, I was pleased to have installed it in about 5 minutes. All tools were still out and ready for use. Thank you for your service
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.