Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11751023
This part is mounted to the side of dishwasher cabinet and helps the rack slide back and forth.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
Unsnap the end covers on the old sliding rack and slide the basket assembly out. This leaves the frames for the rack slide on the right and left side of the unit. Both sides snap out by twisting them downward. Remove the plastic brackets on the new racks by twisting them off. Snap new rack slide frames into the corresponding side of the diswasher. They are marked with an "up" arrow. Unsnap end covers on new rack slide frames and reinsert the basket assembly into the frames. Snap end covers over rack slides to trap the rollers into the slide. When you are finished you should dissassemble the strainer unit on the bottom of the dishwasher by the pump and remove all the small plastic balls that were part of the rack assemblies. They fall out and clog up the chopper assembly and pump.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I purchased two new top rails and replaced them. It was a breeze. The racks actually "popped out" and I popped in the new ones! problem solved, I will buy from you again!
Loosen screws and pulled out dishwasher,remove screws on the old rack tracks and screwed new rack tracks on. Pushed back in dishwasher and tightened screws. Very easyto replace.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.