Quick Question!

Have you ever purchased from PartSelect.com before?

11749221-1-S-Whirlpool-WPW10159107-Turntable Motor
11749221-1-S-Whirlpool-WPW10159107-Turntable Motor 11749221-2-S-Whirlpool-WPW10159107-Turntable Motor http://www.partselect.com/Schematics/Maytag/54224.gif

Turntable Motor

PartSelect Number PS11749221

This motor rotates the glass turntable in the microwave.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, KENMORE®, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Tray won’t turn.

Compare At


You Save


Your Price

Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.5 / 5.0, 2 reviews What's this?
1-2 of 2

21 of 28 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Screw drivers
Customer: Glen from Colleyville, TX

Turn table motor shaft sheared

Removed microwave from cabinet after removing trim. Placed microwave upside down and removed bottom duct work.(two screws)
Base of microwave had a removable panel that gave access to motor. Removed and replaced motor. (one screw and plug in connector)
Replaced duct work, reinstalled duct work and placed microwave back into cabinet. Replaced trim.(four trim screws)
Note: Whirlpool would NOT sell the turn table support because of "liability".

Help other customers find the most helpful instructions.

Were these instructions helpful?   

5 of 6 people found this instruction helpful

Parts Used:
  • Turntable Motor
Level of Difficulty: A Bit Difficult
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Matthew from Edmond, OK

Turntable motor gears stripped

Had a Trim Kit to remove, just 2 screws on the front to pull it out. Had to remove the tamperproof screws on the back (the outer shell is held on by them). I had to goto a local hardware store as nothing anywhere mentioned I needed this special tool (NOTE!!!!!!!) The bottom had normal phillips head screws. Note: I did not take the entire shell off, just bent it enough so the base plate could be pulled out. This exposed the motor, which strangely enough is NOT held in by any screws, just notches it slides in. Took the old motor out, came out VERY easily (only 1 plug to pull out). The new motors flange tab was bent a little bit so I had to use pliers to bend it back flat so it would fit in the notch on the bottom of the microwave (very easy). Overall A bit difficult due to special tool needed 9at least for me)

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2