Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11748479
This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 225 degrees Fahrenheit. The element will kick back in when the temperature drops to 185 degrees Fahrenheit - the differential of 40 degrees.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
It was easy . Romove the top then the front cover then remove the drum ,take the drive belt off before removing the drum .the element board is on the left lower conner , remove the bolts and wires take photo of disasembly for referance then remove the old parts and replace with new .assemble the dryer .make sure that you unplug the unit before you start you repair .
Help other customers find the most helpful instructions.
Were these instructions helpful?
Took the dryer apart and tested the parts with multimeter. Saw that fuse was out. Ordered two fuses and heating element although only one fuse was bad. Just to help the dryer last longer replaced another fuse and heat element. Parts select had the parts their within two days and it was a holiday weekend. We were amazed. Thanks
replaced the limit thermostat,thermal fuse, and cycling thermostat. Bingo. Problem solved. Noticed that the back of cycling thermostat had a buildup of lint and I'm wondering if that acted as insulation and caused a wrong reading of temperature. Did not have to disassemble dryer as I could reach all parts with lower front panel removed. To make it easer to install new parts with one hand I lightly hot glued the screws through the new parts and taped the upper portion of new part to bulkhead. With everything lined up and no need to hold the screws I was able to attach using one hand. It was a reach but easily done.
removed front cover and top took drum out remove heating unit replced limit switch and fuse reinstalled installed new idler put new belt around drum installed drum replaced glides put top back on and front cover . then replaced boosting heater witch is on the blower also cycling thermostat
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.