Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11747667
This part comes with the two door switches but does NOT include the handle.
*** Handle sold separately.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
simply remove the ten screws, lift up the inner door. Disconnect the four electrical prongs on the latch assembly. Connect the new assembly and replace screws. Very simple. Saved 100 dollar service call
Help other customers find the most helpful instructions.
Were these instructions helpful?
Disassembled inside door and replaced sensor board and latch devide and handle. I removed all the screws on the inside of the door, released the circut board(sensor board or control board) and removed each connection one at a time and pluged them one at a time into the new board. I studied the setup before I disconnected anything. Oh yes, I turned off the breaker in the basement before opening the panel on the inside of the door.
I removed the screws from the inside of the doorI removed the existing Control panel (carefully) because the circuit board was also attached here.I installed the new latch assembly on the new control panel.I reattached the circuit board and reinstalled all of the screws - now it works great!Everything for under $100 and less than 30 minutes! Thanks for the parts!
Replacement parts were an exact fit. This always a concern when part numbers have been replaced with a new part number. Removed torx screws from door. Separated door shell, unplugged two micro switches, removed old latch and handle, replaced with new. Previous on line advice was helpful, but repair easy and quick.
I removed the door panel by unscrewing the 12 allen screws and found that the handle hinges broke & latch assembly locking gear was worn down...just normal wear & tear. this diagnostic process just took 45 minutes...remove the door, identify the problem, remove the parts, reassemble the door. I then ordered the parts online.Once the parts arrived, it took me less than 45 minutes to re-remove the door, reconnect the 4 wires to latch assembly, snap the latch handle into place, and reassemble the door.
removed screwsdisassembled door panelinstalled new handle, switch and control panel reassembled door panel
I took off the inside door panel, then it pops off and I pulled off the wires with pliers. Finally, I took off the handle, redid all the steps in reverse and it worked mint!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.