Quick Question!

Have you ever purchased from PartSelect.com before?

11747610-1-S-Whirlpool-WP99001553-Dispenser Door Latch Grommet
11747610-1-S-Whirlpool-WP99001553-Dispenser Door Latch Grommet 11747610-2-S-Whirlpool-WP99001553-Dispenser Door Latch Grommet http://www.partselect.com/Schematics/Maytag/35998.gif

Dispenser Door Latch Grommet

PartSelect Number PS11747610

This grommet for your soap dispenser door is just under an inch long.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Leaking.
  • Will not dispense detergent.

Compare At

$24.47

You Save

$4.08

Your Price

$20.39
Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.7 / 5.0, 52 reviews What's this?
46-52 of 52
 

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 1- 2 hours
Tools: Nutdriver, Screw drivers
Customer: Richard from Murrysville, PA

Leaking water during wash cycle

Removed old gasket. The bottom of the gasket was decaying on each side of door. Cleaned out the gasket groove on the tub. Fitted new gasket without problem, making certain the bottom on each side of door had sufficient gasket material to complete the seal when door was closed. After shutting off power to the unit, I removed the screws holding the door back in place. I disconnected the wire harness to the dispenser latch mechanism. The door back was then placed on the floor with the dispenser mechanism facing up. Removed two screws hold the mechanism in place, lifted it off door and exposed the latch grommet. Remove old grommet, place new one on the latch. Reattched the mechanism, wire harness. Reassembled the door, turned on power and performed a test cycle to check for leakage. No leak, problem solved!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools:
Customer: George from Robbinsville, NJ

Machine developed a leak near the front

I thought it was the door gasket, but I read on this site to order the dispenser grommet since it may be that (besides, it's relatively cheap). I replaced the door gasket, but sure enough, it still leaked. So I followed the advice on how to replace the grommet I found posted here(it's relatively simple, you just remove the screws on the inner edge of the door and take the inner panel out, but search the other posts for more detail) and the machine's fixed.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver
Customer: Dan from Novi, MI

Door leaked at seal and at soap dish latch

Removed the screws holding the inner door panel in place, removed the screws holding the rinse aid dispenser - replaced the latch seal, cleaned the door liner, removed and replaced door seal.

Admired my "door knob"!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: ben from hattiesburg, MS

Water leak on floor

It wasn,t the door gasket leaking but the dispenser grommet, although I replaced both of them. I'm glad I read somone else's review because I would'nt have known about the dispenser gasket and would have had the same problem that I started with. Thanks for great service and delivery times!!!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver
Customer: Daniel from Baldwinsville, NY

Water leaking below the dishwasher during wash

I thought that the door gasket might be the problem but after reading some of the articles on Parts Select web sight, I could see that it might also be the soap dispenser latch grommet and at the cost of the grommet it was well worth replacing that also.

I replaced them both and because I did, I can't say which actually caused the leak but it doesn't leak any more.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 2 people found this instruction helpful

Parts Used:
  • Dispenser Door Latch Grommet
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Alan from Edgartown, MA

Small leak on the right hand side during rinse cycle.

I had to make several attempts as follows:1.I replaced the door gasket, still leaked, 2.Replaced the float and micro-switch, still leaked.3.Replaced the insulation inside the door., still leaked. 4. Finally,read your diagnosis info and ordered the gromet. It was delivered in under 24 hours to my Island home!5.Took off the 7 door screws, unscrewed 2 screws that held the latch mechanism, replaced the rotted gromet and Voila! no leak. Once I found the problem, it took 15 minutes

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 2 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: ken from cape may court house, NJ

Leak on right side of dishwasher door causing small pool of liquid on floor

before ordering parts i noticed lower right side of door gasket was missing about 1 inch. when ordering door gasket i thought for the low cost of latch grommet i should order that also....glad i did. pulled out old door gasket, cleaned where new gasket would go and replaced it. tried the washer and when it reached the main wash the leak started again. took the 7 screws out of door removed 2 nuts and replaced the dispenser door latch grommet.....problem solved. dont think because the old grommet looks fine that is not bad. im not a "repair kind of guy " but this was easy and toof 20 min.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

46-52 of 52