Gas Valve - 60Hz WP98014893

Hi Juan, Thank you for your inquiry. When testing the valve, it should be showing anything between 0 and 5 ohms of resistance. So it sounds like your valve is in good shape. I hope that helps. Good luck with your repair!

Hello Bruce, Thank you for the question. I suggest testing the igniter first. It can light and glow red but may not give enough volts to open the valve. If the igniter is good, the Valve PartSelect Number PS11747502 will need to be replaced. Hope this helps, good luck with this repair!

Hello Craig, Thank you for contacting us. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter. Hope this helps!

Hello Demetrios, Thank you for the question. The Igniter should be between 40 & 400 OHMS. We hope this helps!

Hello Craig, Thank you for the question. The igniter can still glow but not give off enough AMPs for the valve to open. I suggest testing the igniter first to make sure it is strong enough. If so then you may need to replace the Valve. Thank you for your inquiry, good luck with this repair!

Hello Ronnie, thank you for contacting us. We would recommend checking the igniter, part number PS11770066, and the oven sensor, part number PS11749737. These are the most probable culprits of the issue and can be tested with a multimeter for continuity. Also, please make sure the vents of the range are clean. Customer service is always available to help you place an order if you are having trouble doing so. Good luck with your repair.

Hi Timothy, thank you for the question. Based on our research, the compatible gas control valve for your model is part number PS11747502. You may need to replace it to fix the issue. We hope that helps!

Hi Charles, Thank you for your question. If the oven is not heating correctly, the issue may be with the oven sensor. The oven temperature sensor is the part that monitors the oven temperature and signals the electronic control board to turn the elements on and off. Before removing this part from the oven and testing it with a multimeter for continuity, unplug the oven from the electrical outlet. A normal reading should be 1100 ohms, but as readings vary from model to model, you will need to reference your owner’s manual to determine what the correct reading should be. To test it for continuity, use a multimeter on the Rx1 setting and touch the terminals with the probes. This test needs to be done with the sensor at room temperature to produce accurate results. If your test results do not meet the manufacturer’s guidelines, you need a replacement temperature sensor. If the sensor is fine, you will need to check the igniter, the electronic control board and the wiring between the parts to see which one is causing the issue. If you have any questions, please let us know. We are open 7 days a week. We look forward to hearing from you!