Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11746376
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
1. disconnect power,gas and vent lines2. pop off top of unit3. remove front of dryer4. lay unit on its back5. remove drum and replace pulley assembly,belt,drum rollers of which it has 2 rear and 2 front6. reverse above and then remove filter-vent housing and scrape off old seal install new seal7. re-connect power,gas and vent use again8. only sad part to whole job was seeing how cheaply whirlpool now makes thier products
Help other customers find the most helpful instructions.
Were these instructions helpful?
Unplug dryer from receptial. Poped top off, useing thin bladed screw driver to push tintion springs, while pulling up on lid. removed two no 10 sheet metal screws, useing 1/4 nut driver, this removes loading door by pulling uo 1/4 inch. Removed twi NO 10 sheet metal screws useing 1/4 nut driver, removed front carrage system. Removed belt then tub. Removed idler arm spring useing plires, used 5/8 inch socket removed sholder bolt with arm. Reverced procedure with one execption. Used two by four to hold tub up so belt could be put on, rolled tub to alline belt. Not bad for 70 Years young. Curtiss
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.