Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11745474
This part is gray in color and measures approximately 1-1/2 inches wide by 2-1/2 inches high by 1 inch deep. The dishrack roller assembly allows you to roll the rack with ease while the rail supports it. If you notice that the rack is not sliding back and forth easily or the dishwasher is not shutting properly, it may be due to the roller assembly needing to be replaced. The roller assembly may also break or go missing, and will need to be replaced for these reasons, too. You will need to remove the end cap of the upper rack to remove the entire rack. Use a flat-head screwdriver to snap the old roller assembly out of place. The new rollers just get pushed onto the shaft. Use the clips to lock into place. It is common for these rollers to wear down at the same speed, so you may want to replace all the rollers on the rack at the same time.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
The bracket that holds the rack up had broken. I ordered a new part and snapped it in place. Not much to explain.
Help other customers find the most helpful instructions.
Were these instructions helpful?
looked up on line from partselect.com, ordered the part and when it arrived, removed the broken wheel and inserted new one, took 5 minutes
Broken roller assembly on upper dishrack making the rack unuseable - to the point of us looking to replace dishwashing. But before scrapping our unit and spending $600+ -- I wanted to try to see if I could find this $13 roller. After looking at 20 something sights -- I found partselect -- and low and beholed -- they had what I needed! I want to thank partselect for saving us $600+ -- I will spread the word to my buddies. Thanks again !!!
I ordered the part. Sanpped it in. Fixed.
Just popped off the old ones and popped on the new ones. Only thing thiat might have been helpful would have been a diagram of where the roller assemblies should be located.
broke the wheel in the top rack and just popped out the old and popped in the new and the little lady is happy again.
Order was very easy, received on time. Repari was sucessful.Thank you!
Snapped them in place....2 minutes....ordered the parts 2PM on a friday and they arrived 11AM Saturday...couldn't believe it! Thanks!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.