Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11745050
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
removed washer top, checked supply hoses and inlet valve to make sure not clogged, replaced valve and while already there replaced flowmeter, reinstall top and hoses and checked machine operation, machine working fine and wife thinks i am her hero
Help other customers find the most helpful instructions.
Were these instructions helpful?
Ran diagnostics for this model (you can look for its service manual on the web which details how to do this). The diagnostics said the cold water inlet valve or the flow-meter were broken. To pin the issue down to one component, I switched the cold/hot water control cables going into the inlet valve assembly and switched the cold/hot water hoses. Ran diagnostics again and the cold water and flow meter passed but got a failure on the hot water inlet valve. This pointed to a bad cold-water inlet valve. I ordered a replacement at PartsSelect. Installation took less than ten minutes. Machine runs like a dream. Before all this I called a service center, and without even looking at the machine, they quoted no less than $300. But with a little reading and some sleuth work, I ended up paying only $70 for the part + S/H.
check error code : no water flowpulled hoses [hot& cold] to clean screen in line.pulled flow meter out from under top of hood to clean and check free wheel movement inside. still error code F28 in mid wash cycle. called in and talk with service: he explained that hot& cold water valve was opening to slow or not enough for flow meter to read full presure. I replace water valve and flow meter. washer is doing fine. [I was getting readly to go in futher down the line and get new controler. talking to service stop me from spending a lot of money. THANK YOU
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.