Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11744497
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
Once I got the part from Parts Select it was easy. Removed four screws, liftef knobs and face plate. Removed two more screws , lifted assembly(after I shut off power)Removed towo connectors and nut holding switch. Replaced with new switch and and did a reverse of proceedure to put together. Real story was before I found Parts Select I contacted JennAir and their person couldn't understand or help me. I emailed the original manufacturer of the part and found it was obsolete. They did not offet a substitute.10 minutes on line with PS and I had what I needed ordered. Thank You
Help other customers find the most helpful instructions.
Were these instructions helpful?
Piece of cake. Unplug power. Unscrew 4 screws on side. Unscrew 2 screws on top. Pull off top cover and plug in new switch. Switch was not the same but it still worked just fine. Very easy and much cheaper than paying Sears of JoeBlow $100.
Unplugged the unit first of course. Removed the control knobs. Removed 4 screws from the control panel on the side of the stove top.located the fan switch and took out the two connectors. The only little problem was the little bolt that holds the fan switch in place was slightly the wrong size for the new fan switch. I had to go to the hardware store to find a bolt that would hold the switch in place within the unit. after that was located it was very simple to plug the connectors in to the new switch and put everything back in place. If a bolt would have been included it would have been a 10 or 15 minute job.
First I removed 3 screws that held a plate againt the wires. Then pulled the element out about 3 inches and disconnected the 2 wires holding the old element and connected them to the new element. Replaced the plate with 3 screws and I was done.
Removed bottom panel by removing 6 screws. Removed 2 screws holding motor and replaced.Piece of cake! Saved a fortune. Appliance repair service wanted $380.
Removed the part that didn't work and replaced it with the new one
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.