Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11744104
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
** Recommend 2 people to do this job **Turn the circuit breaker to the range off. Pulled the range out, removed the 4 stove knobs, unscrewed the 2 black screws for each stove control. Then removed four white screws from the ends of the control panel assembly. Opened the oven door and removed the four black screws that hold the bottom of the control panel assembly. Pulled the assembly out. From the inside of the assembly, I removed the ribbon cable from the circuit board (you'll notice there's one on the new assembly). Then, I unscrewed the four silver screws that hold the circuit board in place. Carefully removed the circuit board, the 4 stove controls, slid out the 4 stove lights and popped out the 4 red stove light covers. With a nutdriver, I removed the four silver nuts that hold the black metal piece to the assembly.With the new assembly, started by putting the black metal piece in place (4 nuts) and inserted the red stove light covers, put the circuit board in place (sliding the ribbon cable from the new assembly near its port). Screwed in the 4 silver screws, then carefully attached the ribbon cable to the circuit board. Reattached the 4 stove controls (2 black screws for each) and slid in the 4 stove lights. Screwed in the 4 white screws at the ends of the control panel assembly and the four black screws for under the assembly. Turned the power back on. Good to go!
Help other customers find the most helpful instructions.
Were these instructions helpful?
I followed the one description from another consumer, and it was basically exactly as he said. The only tricky part was removing the circuit tape from its original place. We accidentally broke the tiny plastic strip that held it because it was so fragile. Luckily that didn't seem to affect the new one staying in place once we inserted it. The other strange thing was that there was a ring of cardboard around the circuitry that we decided not to put back the way it was. Seemed strange that it was there, as it was flammable. But everything has been working perfectly since.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.