Quick Question!

Have you ever purchased from PartSelect.com before?

11744103-1-S-Whirlpool-WP74005747-Control Panel with Touchpad
11744103-1-S-Whirlpool-WP74005747-Control Panel with Touchpad 11744103-2-S-Whirlpool-WP74005747-Control Panel with Touchpad http://www.partselect.com/Schematics/Maytag/53353.gif

Control Panel with Touchpad

PartSelect Number PS11744103

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Touchpad does not respond.
  • Will not program.

Compare At

$306.16

You Save

$51.03

Your Price

$255.13
Order within the next 11 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 1 reviews What's this?
1-1 of 1
 

27 of 39 people found this instruction helpful

Parts Used:
  • Control Panel with Touchpad
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver
Customer: JOHN from PALM BAY, FL

F1-8 code beeping keypad 6-0 inop

Remove part from box and inspect. Place new part on bubble wrap. Notice only the ribbon cable and key pad come with new part.

Leave room to work.

Turn off circuit breaker and verify power is OFF.

Remove knobs and loosen the two screws for each switch.

Open oven door and place a rack at the highest level. Place a thick phone book on the rack and place a thick folded towel on top of it. This is to act as a protected table when removing and installing the new part.

Remove philips head screws from end covers and from angle bracket and stove. Leave screw nuts and angle bracket attached to old part for now.

Remove old part from stove by lifting up slightly then place on protected rack.

Slide lamp housing from red plastic lens and remove and store the red plastic lens for reuse.

Remove ribbon cable from circuit board. Remove fasheners from circuit board. Remove switches.

Remove old part and remove mounting bracket.

Re-install mounting bracket on new part and reinstall components in reverse order.

Verify that all connections are intact before mounting assembly to stove.

That's All Folks

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1