Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11744000
This part makes sure that no gas is released until the igniter gets enough power to ignite the gas range.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
There were no flames when I turned the oven on, so the first thing I did was narrow down the problem through the process of elimination. It was really a fairly simple system to work on. I verified that it was getting power to the hot surface igniter (which it was). You can check this visibly by seeing if it heats up and glows, but that is not enough. You also have to make sure the igniter is drawing enough amps to open the oven safety valve ( about 3-3.5 amps). You do this by leaving everything connected and turning the oven on as normal. You clamp the Amp Meter (a clamp style Amp Meter works best)to the wires going into the Hot Surface Igniter and checking amperage. If the amperage is to low then the igniter is not pulling enough to open the valve and you should replace it. If the amperage is as it should be then the valve is not opening. The next thing is to turn off the gas to the appliance and unplug the electricity before starting any other work. I removed the oven racks and bottom decking out of the way so I would have room to work. I removed the oven burner to get to the oven safety valve, which is held in by two screws. I disconnected the gas line coming in to the valve using an adjustable wrench, removed the two wires (noting their position) and removed the two screws with a phillips head screwdriver. I replaced the valve with a new one and hooked everything back up in reverse order. That was all there was to it. I also replaced a couple of burners on the top of the stove while I was at it, only because they were difficult to light sometimes. They simply twist out counterclockwise and have two wires that you can't get confused because they have different size connectors and will only go on one way. This 10 year old stove now works like a new one.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I took the oven bottom out and then removed the screws that cover the safety valve, then I pulled the oven out and undid the safety valve in the rear of the oven. This was all accomplished with the electricity off and the propane also turned off. I then reinstalled the safety valve.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.