Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/Maytag/48659.gif
See part 19 in the diagram
http://www.partselect.com/Schematics/Maytag/48659.gif

Single Door Strike

PartSelect Number PS11743868

This door strike is less than an inch long. It is all white in color and it is made entirely of plastic.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Door won’t close.

Compare At

$9.40

You Save

$1.57

Your Price

$7.83
Order within the next 12 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 5 reviews What's this?
1-5 of 5
 

19 of 20 people found this instruction helpful

Parts Used:
  • Single Door Strike
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: William from Greensboro, NC

Plastic clips had broken, causing bottom skirt piece to fall off.

After attempting to order this part from Whirlpool twice and twice receiving the wrong thing, found correct part on PartSelect in about one minute. Shipment came fast and the repair was very simple, under five minutes. You just pop the pieces in place and snap the piece back onto the oven.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 5 people found this instruction helpful

Parts Used:
  • Single Door Strike
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: siri from remsenburg, NY

Lower panal would not stay in place because plastic fastners were gone.

I inserted the door strikes in the proper position and then snapped the panel in place.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

2 of 5 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 1- 2 hours
Tools: Screw drivers
Customer: Daniel from Amherst, VA

1.Access panel door strike broken. 2. 8" element operated at high heat only

1. Pressed new door strike into access panel replaced access panel.
2. Turned off power to stove at main power switch panel. Opened access panel and decoupled down draft fan discharge duct. Pulled range out of counter about 3 inches to clear instrument panel side plates. Removed knob from control switch. Removed 4 screws retaining trim at bottom of instrument panel. Removed 4 screws holding instrument panel in place. Lowered instrument panel. Rotated panel top outward to expose surface burner infinite control switches. Checked all connections to suspect control switch with voltmeter to ensure no residual voltages present. Held new switch in same position as installed switch and swapped connections one at a time. Removed two screws holding old switch in panel and removed old switch. Installed new switch in panel using the two screws removed. Re-assembled range in reverse order above and slide back into counter. Recoupled downdraft fan discharge duct and reattached access panel. Reattached conrol switch knob. Restored power to range at main power switch panel. Turned control switch to High until element was red hot. Turned control knob to Low and verified element heat was reduced normally. (Control switch failure was determined by changing stove top elements and experiencing the same high only heating and loss of heat control. A small jar was used to hold all screwa as removed.)

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 4 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Pliers
Customer: William from Monroe, MI

The strick and latch broke

I used a pair of plyers to remove both items and pushed new items in holes. Job complete

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
  • Single Door Strike
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: Tomi from Steilacoom, WA

Missing door strikes

Just plugged them in and reset the door,.

Just great.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-5 of 5