Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11743838
This cut-to-fit door shelf retainer bar is twenty-six and a half inches long. It is all white in color and it is made of metal.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
I received the door shelf bars. They were 26 inches. I used a hack saw and cut them to 22 inches. Put them on.Perfect fit!!
Help other customers find the most helpful instructions.
Were these instructions helpful?
had to cut approximately 1/2 inch off. It was a bit to thick used the pliers to squeeze it to a thickness it would fit in the slots
I had to cut the bar to the right length with a hacksaw. The most difficult part was getting on the plastic supports/pins on either end. I'm not sure a hacksaw is the best way to cut a retainer bar, but it worked.
fast and easy. I got the right parts from the begining.
ordered new retained and fastners cut to length per instructions installed repair completed thanks for your service all parts were correct and deliver on time wayne winkler
The firt hard thing was waiting for the part to arrive, but that went quick. The second hardest part was opening the box. Shucks I got a paper cut, should have used a razor but while wife wont let me have sharp objects. Oh, yeah I had to find the hachsaw. I fooled everyone I knew where that was too. Be sure to measure properly, because if you cut too short then you have to stretch the bar. I havn't found any type of bar stretcher that works. It's best if you clamp the metal bar to a 2 X 4 piece of wood in order to steady the metal bar while you cut. You can't cut to well trying to hold the metal bar in your hand. The best part was completeing the job by installing the bars. Finally I have more room in my freezer to store food in the doors. This is my story and I am sticking to it. Have fun.
I simply measured for the correcy length, cut with a hacksaw, inserted the ends that attach it to the door and installed it on the door ..... simple.
nothing exciting - I cut the retaining bar to the correct length, inserted the clips in the bar and pushed them in the holes - voilia, new bar in place.The temp control discs were the same, push in place.
had it done by my husband, I did not do it
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.