Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11743508
This part is used to divide your pantry drawer.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
first I removed the pantry drawer and the 2 crisper drawers. Then I removed the glass shelf and it's supports. Using a nut driver I removed the 2 screws holding the end cap to the side of the refrigerator. Carfully snaped the end cap loose of the clip in front and pulled it straight forward, being carful not to break the rear tabs holding the climate adjuster. I then removed the old climate adjuster from my broken part (it's held on by clips) and installed it on the new end cap. I put the new end cap in snapping it onto the existing clip and added the 2 screws. Put the shelf supports and glass back on top of the drawer, slid back in the crisper drawers, installed the divider into the drawer (it just slides in) then put the drawer back in and I was done. It was an easy job and I'm sure I saved at least one hundred dollors for 20 minutes work.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Easy repair here, the Refridge was purchased at a discount as a scratch and dent model. the damage was superfical and the parts orderd were simple remove and replace job did not take long at all to replace all parts.Divider pantry: no tools required, simply pull out tray and remove old broken dividers and snap new divider in place.Brace-Crisper: this takes a screw driver to remove. remove the crisper shelf and insert a screw driver to lift the plastic securing tab. slide out the frame brace and slide the new brace in place the plastic tabs will snap in to place and hold the metal frame in its position.Grille, Toe: this grill snaps into place no tools required.Bracket: this is the metal bracket for the front feet, there are 4 screws to remove and the bracket comes off the front of the refridge. unsrew the adjustable screw foot and screw the adjustable screw foot into the new bracket......install the 4 screws and you are done.Trim-Shelf: no tools required simply pry the trim piece of with your fingers.....some may use a flat screw driver but this riskes scratching the trim piece. the new trim piece snaps into place.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.