Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
You searched for PS2060635 but the manufacturer has replaced it with this part.
PartSelect Number PS11743223
This valve has a 1/4" tubing inlet connection. When energized, this part releases water from the supply line into the ice mold.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
1. Unplugged fridge.2. Unplugged wire harness from valve.3. Disconnected water supply from valve.4. Removed valve from fridge chassis5. Removed plastic tube from valve (supplies ice maker).6. Removed old fitting from plastic tube and attached to new valve.7. Attached new valve to fridge (only need 1 screw)8. Attached water supply to valve9. Reattached wiring harness10. Turned on water supply, checked for leaks11. Powered on fridge.12. Enjoy working ice maker.
Help other customers find the most helpful instructions.
Were these instructions helpful?
removed card board protection.4 screws. Unpluged refrigerator unscrewed the screw holding the valve but not all the way. disconnected the electric connection. removed the water connection after disconnecting the main water valve. replaced valve by reconnecting everything. Turned on water to check for leaks. Easy fix and recieved the part sooner then expected. Will highly recomend your fast service and correct part replacement. web site was easy to use. THANK YOU
Start: UNPLUG THE REFRIGERATOR FROM POWER! Then -1. Shut off water supply to ice maker.2. Remove panel from back of refrigerator to expose single outlet water valve.3. Disconnect water supply line from single outlet water valve.4. Remove single outlet water valve from refrigerator (one screw).5. Disconnect water line from the ice maker side of the single outlet water valve.6. Reconnect the water line from the icemaker side of the old valve to the new single outlet water valve.7. Re-attach the new single outlet water valve (with water line leading to the ice maker attached) to the refrigerator.8. Reconnect the water supply line to the single outlet water valve.9. Turn on the water and check for leaks.10. Replace panel covering single outlet water valve at back of refrigerator.Finish: PLUG THE REFRIGERATOR BACK INTO POWER.
The whole job went smoothly,just the way others have described it. Unfortunatlly the water valve was not the problem. The problem was that ice had formed where the water enter's the tray . and therefore could not get into the ice forming area and just spilled into the refrigerator. I removed the ice maker(2 screws and cable connector.) let the ice melt and reconnected all is well again.
used 1/4 inch wrench to remove bottom screwand loosend tip screw and removed valve wires and water line
Ordered new part by the numbers and pics. and installation was so easy. I thank you very much
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.