Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11743069
This part has been redesigned by the manufacturer and is now a complete full basket with handle and covers.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
It took no time at all. Parts were easy to find. Thanks
Help other customers find the most helpful instructions.
Were these instructions helpful?
Took out the old basket,Threw it away.Popped in the new baskey,filled it with forks and spoons. Works great!By the way, my order arrived in one day. Phenomenal!
Very simple. Just replaced the old one with the new one. Voila!!!
Open the door and remove old basket. Place the new basket in its plave. Time elapse approximately 20 seconds
Ordered a new basket. Tossed out the old one. Done
The "repair" was actually a replacement. My wife did it. She took out the old, damaged basket and dropped in the new, replacement basket. She removed the slotted lids because she doesn't think they are necessary and she doesn't like them. I got the old basket for holding small items in my workshop. The lids will be thrown away, unless I can come up with a use for them.
I removed old hinge and snapped in new one.The new basket was identical to the original and PartSelect.com was the only source I found that had it in stock. I took the old handle off the broken basket with a screw driver and snapped it in place on new basket, job done.
The only problem was the handle arrived about week before the basket because of an inventory problem. The fix was to insert the handle into the basket and we were ready to go. No tools and no mess taking a minute or two to accomplish and it is as good a new. Thanks!
Ordered silverware basket, placed into the proper position. Easy as pie.
pulled out old door gasket and on the third try it fit perfectly.took out 8 screws on the door, seperated the plaster inner door from the outer. undid 2 screws to replace the dispenser door latch gasket.dropped the new silverware basket into the dishwasher and put the 8 screws back in.it closes a bit tigher now, but it does not drip...Thank you...
Replacement basket did not include handle so needed to pry old handle off broken unit to use on the new one. Used screw driver to pop loose clips which attached to basket. Had to stick tooth picks broken in half under them to hold out until all four clips were opened at once - then handle could be pulled off. Easily snapped it back on to the new basket and repair was done. Can't get any easier than this!
seeing as how my husband was out of town, I inserted a regular flatware knife in each of the four slots that held the handle in place on the basket. I then slowly pushed down on the handles of the knives on opposite sides of each other to unlock the handle from two slots on the basket and then went on to push down on the other two flatware knives on the opposite sides...sure enough, the handle came right off...less than 5 minutes in all to take the old handle off from the old basket and then snap it into place onto my newly acquired basket.
Removed old unit, snapped handle onto new unit and installed itNOTE: THE DIMENSIONS SHOWN ON THE ORDERING GRID ARE NOT ACCURATE. THE UNIT IS MORE LIKE 9 INCHES LONG INSTEAD OF 11 AND 6 INCHES WIDE AS OPPOSED TO 7.This error occured on several websites so I suspect that Maytag's specs are off.
When the (overpriced) replacement silverware basket arrived (rapidly, within a few days of my ordering) I was shocked and angry that the handle for the basket was not included--nor were instructions included as to how to remove the old handle from the old basket in order to fasten it to the new basket. Therefore, I spent a considerable amount of time trying to pry the handle off the old one, which was quite tricky: There were four slots which held the plastic "catches", and they had to be pushed out simultaneously. I had to fiddle with it for at least a half hour, trying various implements, until I found that I could push them out simultaneously by wedging butter knives into the slots and then easing the handle off. (I was careful to position myself so that I wouldn't slip and stab myself with the blunt butter knife.) After that, the handle snapped fairly easily into the new basket's slots. In the end, while I was glad to be able to recycle the old handle, I wish that the basket and shelves were made more durably so they wouldn't have to be replaced, or that they could be replaced at a more reasonable price.
take handle off old basket put on new basket done
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.