Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11742841
It comes with a flame shield/flame spreader.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
I took the oven bottom out and then removed the screws that cover the safety valve, then I pulled the oven out and undid the safety valve in the rear of the oven. This was all accomplished with the electricity off and the propane also turned off. I then reinstalled the safety valve.
Help other customers find the most helpful instructions.
Were these instructions helpful?
It was so easy, I pushed the panel towards the back and lifted the front up then lifted it right out. I am so glad that you had the part. I ordered it and when it got here, I just sliped it right in, perfect fit! Thank you so much! Cindy Brison
*Oven floor panel was blocked by fan guard.* Had to remove fan guard first as I have the convection feature. Easy. 6 screws.Replaced the oven floor panel, stained and warped. Checked the ignitor switch by trying to preheat oven. Switch heats up but not enough to ignite gas. Replaced the Ignitor. Easy. Plug and Play. Replacement insulation comes with the ignitor.Thank You Parts Select. Youre my new favorite website. I can't wait until my next appliance breaks down.
slide latches in rear of floor panel forward and remove.
Very simple and stressfree - popped out old - popped in new.
I found the panel on the innernet, ordered it and when it arrived I removed the old one and replaced it with the new one.
If your food is not cooking evenly, a warped floor panel with attached difuser (or "v" shaped heat shield) may be the cause. Simply slide the 2 clips to unlock the panel and move the entire assembly up-and-out (back first) and slide the new one in. Be sure the clips are lined-up with the holes in the back of the oven. The new floor panel comes with the new heat shield.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.