Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11742481
This kit is intended for use with refrigerators that have a water dispenser in the door.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
Popped fromt pannel off from bottom side removed 2 screws from control bracket and took switches etc. off old bracket. removed broken water tube and cut top off. Secured black tubing together and pulled down through door fastened into exixting fitting repolaced one screw. placed switches onto new control bracket and okaced back with 2 screws. Snappec ice guide in place then replaced cover into notches in top and snapped into place. incerted 2 new door handle trim clips into trim and slid into place,,,,finished
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed screw that held nozzle on. Pulled old line out far enough to cut off broken nozzle. Attached new line with threaded bolt and clear packing tape. Pulled old line out bottom of door until new line came thru. Removed tape and bolt. Attached new line to water supply. Attached new nozzle with screw. Checked for water leaks. Job complete!
We pushed the water return hose up from the bottom of the freezer door then we cut the water hose off then we taped the new water hose to the old one using electrical tape then we pulled and pushed at the same time and ran it back down through the door, be careful when you get to the bottom of the door it might stick a little going through the door , on my first try the tape came off without the new hose coming through. Just run the old one back up through the door and re tape it and try again. The connection at the bottom is just a pull out and push in connection and it won't leak after you push it in.
Removed old nozzle and threaded in new one as many others have described. The most difficult part was removing the entire plastic enclosure that the dispenser is housed in, as the supply line was securely taped to the back side. Once the tape was removed, the job went very quickly. The tape may be unique to Whirlpool as no one else has mentioned it.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.