Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11742075
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
First I watched the "how to video" that corresponds with the part I ordered on the Parts Select web site. The instructions given in the video were so clear and complete that the job was incredibly easy. Parts Select makes appliance repair so easy that Im willing to bet that even the "May Tag" repair man becomes more lonely
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed time knob and dial. Removed two screws hoding Console. Lifted Console up and laid it back. Removed two screw holding timer to control bracket. Unpluggd timer connections. Plugge connections into new timer. Replaced two screws holding timer to control bracket. Placed Consel in positon and replaced screws holding console to base. Replacd timer knob and dial. Tested wassher through cycle.
Took out two screws on back of top consule. Lifted consule up and over to expose timer and wires. Removed two screws holding timer. Undid three electrical connectors. Removed timer. Put in new timer and plugged in connectors. Replaced screws and walla. Working fine. Thanks PartSelect!
First UNPLUG THE WASHING MACHINE. Then unscrew the knob and then pull off the bezel (with the arrow on it). Then remove two screws alont the top-back of the unit. Then the two screws located at the base of the control panel section (about six inches from the top - in the back). The cover slides off to expose the timer. There are two more screws on the front (under where the knob was located) that hold the timer in place - they need to be removed. Then pull out the three wire harnesses (I saved the small one for last since it was the hardest to remove - I needed a small screw driver to push down the small plastic latch). Switch out the old timer for the new one and reverse all the steps.
1. Removed wet clothing, evacuated water using Python No Spill Aquarium Maintenance System. No mess or water on the floor. 2. Turned off hot & cold water supplies, and unplug unit before moving. 3. Removed unit water supply hoses, and moved unit. The drain hose remained attached while moving to prevent spills. 4. Removed unit from laundry room, and took to the garage on a dolly.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.