Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11741905
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences. Note: You should use your washer's model number to verify that this is the right timer for your machine. Though most timers look alike, they are quite different.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This job was extremely simple. First I unplugged the washer and disconnected the water supply lines. Then I removed the top of the washer control panel (2 hex screws) and then the back side of the control panel (3 Phillips screws). The front of the control panel then pivots forward towards the washer lid, giving easy access to the timer assembly. Unfastened old timer assembly (2 hex screws). Unscrewed timer knob on the front of the control panel, and pried off the plastic disc beneath that knob, thus freeing the timer knob post so I could pull it through the front panel for removal. Last I simply unplugged the jumble of wires that go into the timer, since they all conveniently come together in one plug. Reversed all of these steps to install the new timer assembly. Total time: about 45 min.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Pulled the electrical plug. Unscrewed the control know (counter clockwise). Gently pried off the round plastic plate under the control knob. Took off the outside cover. (2 screws). Took off the inside cover (3 screws). Disconnected the wiring harness from the timer. Unscrewed the 2 holding the timer in place. Replaced in opposite order. Connected timer, connect wiring harness, Attached inside cover, attached outside cover. Pushed in round plastic plate (make sure you line up the notches) screwed on the control knob.
Remove three screws on back cover ,removed two screws holding timer and disconnected wire harness plug , replaced timer and put back together.
Removed the screws that held the top console which housed the timer. (5 minutes)Laid the console over. Just rocked it forward. Removed the 2 screws holding the timer in place.Unplugged the wireing harness from the old timer.Plugged the wiring harness into the new timer.Replaced the timer and re-screwed it in place. Pulled the top console back up and re-screwed all the screws. Pushed the washer back in place and turned it on. It worked fine. Took maybe 20 minutes.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.