Quick Question!

Have you ever purchased from PartSelect.com before?

11741465-1-S-Whirlpool-WP3394196-Blower Motor Shaft Seal
11741465-1-S-Whirlpool-WP3394196-Blower Motor Shaft Seal 11741465-2-S-Whirlpool-WP3394196-Blower Motor Shaft Seal 11741465-3-S-Whirlpool-WP3394196-Blower Motor Shaft Seal http://www.partselect.com/Schematics/Whirlpool/XLGMNG6X.gif

Blower Motor Shaft Seal

PartSelect Number PS11741465

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$10.38

You Save

$1.73

Your Price

$8.65
Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

16 of 29 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 1- 2 hours
Tools: Nutdriver, Screw drivers, Wrench set
Customer: Eric from Fort Dodge, IA

Dryer drum not turning and no air circulating

replaced motor and drum rear seal as well as idler wheels, the old rear drum seal was completly worn out, since I had it all apart, I replaced lint chute and trap seals and belt and tensioner. I spent less money on parts than if I would have bought a new dryer. The motor was the main problem as the bearings were shot.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 1- 2 hours
Tools: Nutdriver, Pliers, Socket set, Wrench set
Customer: James from COTTONWOOD, CA

Motor failure

Used this resource and others' advice -thank you . Make sure to disconnect power first. I had replaced the rollers and tensioner a week earlier due to squeaking, but mine was the rare one where squeaking meant motor failure, so I had to place another parts order. The dryer was 19 years old, and my blower wheel did not simply 'unscrew with reverse threads'. During removal the blower wheel's plastic deformed, so had to do like someone else did and cut the rear shaft with a reciprocating saw. Just be careful not to damage the bulkhead's built-in bracket that anchors the rear of the motor. I think it was a 13/16" wrench that fit the blower wheel and I forget the size for the pulley nut on the front of the motor, but I suggest a deep socket since it held well. My best advice when dealing with a motor replacement is to ensure the blower wheel wheel will separate successfully from the motor before placing your parts order should it be a stubborn removal. Good luck.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2