Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11741429
This part senses the flame for heat allowing the gas valve to open.This flame sensor is three inches long and is used for many gas clothes dryers.This flame sensor assembly is made of both plastic and metal.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
I purchased the "m" series ignition coil kit per" ask how repair man". Installation was straight forward. Simple repair when correct parts are used.
Help other customers find the most helpful instructions.
Were these instructions helpful?
removed frt & rear panels & drum and lint chute for seal replacement replaced these components, problem didn't go away, ordered & replaced both gas valve coils (m series coil kit) problem solved
Removed and replaced both the thermostat sensor and the ignitor. Tested thej dryer and it worked. Replaced the front panel and it was good to go.
as i took a part out I put back wire for wire part for part took my time no distractions great to have this service would use again and tell a friend or friends great stuff saved $$$$$$$ thank you for being their love this internet
Found on your site the top two causes of a Dryer not getting hot enough and ordered those parts ( which were delivered quickly).Removed the top two screws that hold the front of the dryer that gives access to the coils and flame sensor assembly after lifting up the top.It took more time to clean up all the lint than to replace the parts.Dryer works great!
Prelude to this was 2 years ago we had the same problem, called Sears and $200 later we had a new $16 dollar part, the repair guy was kind enough to tell me what he did, and I saved the fuse he replaced. So when it happened again this summer, I went through a couple of sites (obviously including this one) to find parts, started with the fuse he had replaced, which was not the problem this time, went on to the next likely, and on through about 5 key elements (all under $20) until I found the coils on the burner assembly were the problem. All in all the repairs were pretty simple, and once I figured out how to dismantle the cabinet safely. I am VERY happy with the timely replacement parts (shipped very quickly) and when your dryer isn't working-things pile up pretty quickly. The dryer is working like a charm again. Thanks! -Mike
Unplug unit turn off gas, remove only bottom front panel first tried radient flame sensor was not the problem it was the coils which were infront easy to acess with small screw driver remove two prong coil and replaced then the three pronged coil being sure to line them back before tigtening left off cover and watched for ignition once it turned on and ran replaced cover and done.
After the Radiant Flame Sensor was installed, the problem remained. An appliance repair person then replaced both coils, and that fixed the problem.
First tried to clean the ignitor, broke it and replaced with new. Problem not yet solved. I read a review where one guy replaced all components as they were reasonably priced so I did the same. Replaced coils and flame sensor (which I was going after next anyway). Dryer is now back in service and the house is back to normal.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.