Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11741080
This timer assembly is almost five inches long. It comes with a chiming mechanism and runs at 1/3 horse power.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
Removed old timer assembly, put the new one next to it and as I disconnected one wire from the old part, I connected it to the new part, that way I was able to connect each wire to the right place.It was very easy.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Appliance dealer stated that usually timers did not go out and thermostats were most likely . Tried all and called repairman that did not show. Removed cover found burned gear in timer ordered. The part is easy to replace just change wires one at a time or take a digital pic of the wires.
I replaced the timer and timer dial skirt which was very easy to repair. The dryer would not shut off and the timer would not advance. I could manually use a plier to move the timer and it would shut off then. I replaced the timer and it works well now.
Ordered the three pieces of the dryer dial and replaced the old dial with the new one.
remove back cover 3 screws, change wires in same order as old timer, remove two mounting screws under timer dial, check voltage-replace temp sending control attached to brown wire.
Had the dubious distindtion of having two switches (start switch & the timer) go bad within 3 months of each other. The start switch has been previously discussed.The access plate to the controls is secured be 3 phillips head screws and 2 nut-driver bolts.The switch itself is secured from the front of the machine be two phillips head screws, located underneath the knob which is easily pulled off. Just replace the wires one-by-one using needle nose pliers on the clips .A real no-brainer.
Removed the knob. Removed back panel. Removed the timer (2 screws). Pulled off wires and put them on the exact same spot on new timer. Attached new timer and replaced panel. Dried my cloths to perfection! (While I took a nap)
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.