Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11741067
This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you will have to replace it when it blows. Use it for your Maytag brand gas or electric clothes dryer.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
Remove 2 front door screws and 2 side cover screws . Remove front cover replace switches and fuses.De- lint the blower and vent duct.Reinstall cover door finished.
Help other customers find the most helpful instructions.
Were these instructions helpful?
We tried replacing the door switch first, still didn't start. Next we tried the thermal fuse and it turned on and has worked ever since.
took old one out then i had to strip the connector off new one was to big...
Removed front cover, removed old heating unit, installed new thermostat,heating coil inside the dryer and finally replaced the fuse in the front. The main complication was reaching the screws for the heating coil, not really complex.
unplug dryer; remove dryer door; remove front cover; thermal fuse located on heater underneath and beside drum; remove two electrical leads on fuse; remove two screws holding fuse in place; install new fuse and do the above in reverse; clean lint from duct; plug dryer into
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.