Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11739288
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
First, I pulled the press-fit knobs for the load size and water temp, then after prying the face cap from the timer knob, I was able to remove the clip, knob and spring portion of the timer knob assembly. Then, I removed four phillips screws at the top of the washer which held the face plate and frame, allowing access to the timer and its wiring harness . The timer was held into position by two small hex screws,which were exposed after the timer knob assembly was remover. I backed themout with a nut driver. After removing the wiring harness, the new timer as very easy to install. I would say it t ook me 10 to 15 minutes to remove, and replace my maytag timer and save over $200 as quoted by a repair service.
Help other customers find the most helpful instructions.
Were these instructions helpful?
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.