Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11739287
The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
First removed two screws holding control panel,once those are out, you remove the center plastic on the selector button,remove the metal retainer and take the button off the outside of the panel ( be careful of the spring behind the button) Next there is two bolts screwed from the front that hold the timer in place,remove these and the timer is removed, unplug the electrical wire plug from timer and you have it . Just reverse the steps and your all done!!! easy repair! Maytag repair man wanted over 100.00 just in labor! I did it in less than 30 minute's and that was just trying to find some tools.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I received the part next day, just as promised. I removed two screws to take the top panel off the washer, removed the two screws on the old timer and put the new timer in. Had the repair done withing 15 minutes - I have replaced this before, I am 54.
First removed the cover off the control knob on the front of the control panel. Then removed the clip holding the control to the timer. Watch for the spring that is under the control knob as you pull it off. Then remove control ring set them aside. Next unscrew the two screws holding the timer to the control panel. Next unscrew the screws holding the control panel. Removed control panel. Next unfasten the wire harness from the timer. Remove timer and install new timer. Replace wire harness to new timer. Screw new timer to control panel. Replace control panel and screw into place. Replace control ring then timer knob with spring. Replace cover on control knob. Simple, Easy and Fast.
Removed timer, ordered par;t and, upon arrival installed timer -- washing machine works like a champ.Easiest repair I've ever made.Respectfully,W. E. Akin, Jr.
Remove cap on the knob, remove clip under the cap. Pull off the knob and bezel. Remove four screws on top of the control panel tip panel forward & remove timer screws. Disconect wiring plug from old timer. Very simple operation.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.