Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11739223
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
Followed directions enclosed with new ice maker.1. Unplugged refrigerator. Removed three screws holding ice maker with a 1/4" nut driver while supporting ice maker with free hand2.After removing ice maker from sidewall, unplugged wire pigtail and removed entire ice maker unit3. Installed new pigtail, and bail wire from old ice maker, onto new ice maker4. Holding ice maker with one hand, inserted new pigtail into plug, aligned water fill tube and held unit in position to reinstall 3 screws with 1/4" nut driver5. Set wire bail in down position, plugged refrigerator power cord back in. About an hour later had new ice cubes. This was a much easier job than I had anticipated. Thank you PartSelect! I am a happy camper once again. This refrigerator is in my motorhome.
Help other customers find the most helpful instructions.
Were these instructions helpful?
My wife had the shelf end caps and trim replaced before I got home. The shelf support stud was very easy to install. A pair of pliers and a simple turn and the broke piece was out and the new one was in.
FIrst I ordered the part on line...did it on a friday..got the part monday..really fast..! Pulled the old end cap out of the refigrator door..then slid it off the end of the shelf front...slid the new one on the shelf front and pressed the "keeper" into the door...wolla, it was fixed...
removed owner applied "tape" and broken end caps from shelf.replAced end caps and snapped back into door slots. very simple operation butthe highlight was relative ease in finding parts at partselect. i was afraid given the age of refridgerator i would not be able to find replacement parts.once i found their website and described part it popped up in-stock and in several different colors. THANKS PARTSELECT!!
Removed the old ones , this was easy because the clip part of the end cap was broken off. I simplyinserted the plastic clip part if the new end cap into the slot in the door and presto it was done.Then I replaced the other end cap the same way
The repair went very smooth, and fast. First I made sure I looked at markings for correct side. I snapped bottom in first and top snapped right in.
I just popped off the broken end caps and put the new end caps on. Very easy and new parts fit perfectly and work well.
It was actually very easy since the parts were already missing. It required no tools just some elbow grease. The end caps snap on to the retainer bar very easily. Once they were put together it was just a matter of snapping them in to place on the refrigerator door. You do need to line them up and I found it easier to snap them in on the bottom first and then snap in on the top next. Very simple and for the money I spent on parts I have a used (garage) refrigerator in good working condition for right around $200.00. I would definitely order from PartSelect again.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.