Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11739139
The motor turns the auger to dispense ice when required.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
no ice came out from the door dispenser after researching here i found it to be the auger drive motor for the ice dispenser cost $50.00 but was well worth it took less than 15 minutes to replace and was super easy to do. saved on service calls and repairman cg's. directions on how to were also found here and very helpful. i highly reccomend this site if you are a little mechanically inclined you can fix and save big!!!!!!!!!
Help other customers find the most helpful instructions.
Were these instructions helpful?
Ice machine would not turn, dispense, or crush. Made ice fine. First, replaced switch for $7, did not fix it. Second, replaced motor for $80. Old motor was metal, new motor is plastic, but replaced it in 20 minutes, works like a champ. Inside freezer door, took off shelf under the ice maker, unplugged frig, removed two screws and cover plate, removed four screws on motor bracket, unplugged motor, plugged in new motor, replaced bracket and 4 screws, replaced cover, plugged frig in...Perfect!
With the exploded (Printable) view of the assembly for my fridge available on this site, it was a breeze removing the existing ice dispenser motor and replacing with the new one. Ice dispenser work like new, now. I have never had a bad experience from Parts Select.
removed first wire rack in freezer door this will give you access to the 2 screws for cover to get to motor for ice dispenser/ crusher then removed wire connector to motor. you have to pull back on tab for locking connector to release from terminals. next used nut driver to remove 4 screws holding motor to shaft , installed motor lining up keyed shaft. reinstalled 4 mounting screws for motor. reinstalled 2 screws for access cover and then reinstalled wire rack into freezer door squeezing together to get it back into holes where it pivots
First I removed the 2 screws holding the cover on. I then disconnected the wires harness before removing the 4 screws holding the motor in place. I reversed these three steps and wala, the ice dispenser now works perfectly.Thanks
Removed two screws on inspection plate underneath second shelf on inside of the freezer door. Removed four screws holding motor that turns inside ice bin.Unplugged wires and reinstalled.
First I removed the plate inside the freezer to get to motor, then unplugged the wiring harness to the motor and removed the motor. inserted new motor, plugged in harness,replaced the plate, and now that baby spits out ice again!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.