Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11739031
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
The overflow grille was no problem. It just slides out. To get to the levers, you need to remove the front cover trim. Pay attention to where everything is before you remove parts and how the wiring is set up (over or under parts). There are two slots below the trim, use your blade screw driver and pop the trim. You'll notice that the 4 buttons for ice (crush - cube) and the light (off-on) are on that panel. I don't recall well, but I believe two screws (one at each side) hold that part in place. Once loose, I flipped it up, disconnected the white multi- wire quick connector and used duck tape to tape the panel to the door and keep it out of the way. Another screw keeps the levers in their place, with a metal element. Remove it and the levers will come out. The ice guide just snaps out from two sides and a middle plastic hook of the ice dispenser lever. Replace everything in reverse order. That's about what I remember. Hope it helps.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I replaced these parts mainly for aesthetic reasons and to prepare our home for a rental. I was very impressed with PartSelect's customer service and delivery. The part literally arrived the next day. Will definitely do business with them again.
Some screw not easily accessible. I broke the ice dispenser mechanism but could glue it back so everything fine for now.
All the parts were easy to find on the website and they arrived within a few days.Only needed a screw driver to remove the old water arm dispenser and to install the new one. The drawer, the ice guide and the grille/tray all snapped in place.
To replace front cover and ice door kit I had to check the new cover how it is cliped on the bottom to remove the old cover, but after that it was not very difficult.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.