Quick Question!

Have you ever purchased from PartSelect.com before?

11739030-1-S-Whirlpool-WP2180259-Ice Dispenser Arm - White
11739030-1-S-Whirlpool-WP2180259-Ice Dispenser Arm - White 11739030-2-S-Whirlpool-WP2180259-Ice Dispenser Arm - White 11739030-3-S-Whirlpool-WP2180259-Ice Dispenser Arm - White http://www.partselect.com/Schematics/Maytag/MWAJKNP1.gif

Ice Dispenser Arm - White

PartSelect Number PS11739030

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$46.08

You Save

$7.68

Your Price

$38.40
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 4 reviews What's this?
1-4 of 4
 

38 of 52 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Mario from Oklahoma City, OK

Replacing still working but old and stained levers

The overflow grille was no problem. It just slides out. To get to the levers, you need to remove the front cover trim. Pay attention to where everything is before you remove parts and how the wiring is set up (over or under parts). There are two slots below the trim, use your blade screw driver and pop the trim. You'll notice that the 4 buttons for ice (crush - cube) and the light (off-on) are on that panel. I don't recall well, but I believe two screws (one at each side) hold that part in place. Once loose, I flipped it up, disconnected the white multi- wire quick connector and used duck tape to tape the panel to the door and keep it out of the way. Another screw keeps the levers in their place, with a metal element. Remove it and the levers will come out. The ice guide just snaps out from two sides and a middle plastic hook of the ice dispenser lever. Replace everything in reverse order. That's about what I remember. Hope it helps.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

10 of 13 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers, Wrench set
Customer: Diana from GILBERT, AZ

Water and ice dispenser discolored

I replaced these parts mainly for aesthetic reasons and to prepare our home for a rental. I was very impressed with PartSelect's customer service and delivery. The part literally arrived the next day. Will definitely do business with them again.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

11 of 21 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 1- 2 hours
Tools: Screw drivers
Customer: Serge from San Jose, CA

Water and ice dispensers were old with hard water

Some screw not easily accessible. I broke the ice dispenser mechanism but could glue it back so everything fine for now.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

5 of 18 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Screw drivers
Customer: Jacob from Miami, FL

Ice door holder brocken

To replace front cover and ice door kit I had to check the new cover how it is cliped on the bottom to remove the old cover, but after that it was not very difficult.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-4 of 4