Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11738835
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
It auger would barely spin and the machine would squeal to a stop after the spin cycle. After reading some other posts on here, I decided that it is most likely the brake so I bought the brake repair kit. Because the machine was old, I took the time to clean it while I was repairing the brake; thus the extra time, but it was well worth it.1) go to hard ware store and buy 6 2" #10-24 screws; they will be required to remove and install the brake spring2) you have to gut the machine (which is very easy) - working from the top * unplug, drain water, and move it to an open space where you can easily work on the floor around it, and where you have a wall to support the top panel of the machine * tilt washer on the side and remove the drive belt and pulley from the main shaft in the center * lower washer and then remove the front panel and raise the top panel to rest against the wall/backstop * remove the auger * remove the white top from the tub * remove any hoses connected to the plastic tub * now you can push the tub to each side so that you can remove the springs - it is easier if you have someone push the tub down from the top while you remove the springs with pliers. * remove the tub3) remove the brake - working from the top with the tub turned upside down * remove every other screw from the break and replace with the 2" screws * remove the remaining original screws and replace with the 2" screws * now, release the screws so that the brake spring is release with equal pressure on each screw * remove the brake guts and replace with new4) now would be a good time to clean out any mold and mildew5) re-assembly is opposite of removal* * the springs are more difficult to attach, and I would recommend starting with the spring in the back, by the drain and working towards the front of the washerMy machine is now quieter than when we first bought it! The brake was the problem!03-2011
Help other customers find the most helpful instructions.
Were these instructions helpful?
Tried to remove brake stator with machine tilted back. Thisforced the stator off center. Removed the 6 holddown springs, water level hose and drain hose. Pull drum & transmission out of the case. Placed the drun on the ground, brake facing up. Replaced the short screws on the brake stator with 2" screws one at a time. Caution the spring has 200 lbs of force. Used 2" screws to back off spring. With spring tenshion released replace parts. Reversed proceedurer. Machine quite. Wife is happy.
first remove drive belt then then remove dust cover on bottom of shaft take 5/16 nut driver to only 4 of the screws off that hold the brake cover on install 4 5/16 screws 1" long in those 4 spots.reomve rest of screws then slowly reomve back out 1" screws to relve spring pressure from brake pad.install all new parts from partsselect.com then install other part taken off in oreder and make your wife very happy
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.