Quick Question!

Have you ever purchased from PartSelect.com before?

11738697-1-S-Whirlpool-WP16123-Water Inlet Hose Washer
11738697-1-S-Whirlpool-WP16123-Water Inlet Hose Washer 11738697-2-S-Whirlpool-WP16123-Water Inlet Hose Washer http://www.partselect.com/Schematics/Maytag/0LV69EEL.gif

Water Inlet Hose Washer

PartSelect Number PS11738697

If your clothes washer is leaking, it is likely that there could be an issue with one of the hoses. If the hoses are in working order, you should check the washers connecting the hose to your unit. Rubber washers are tasked with enhancing the seal between the hose and washer. A faulty or damaged washer will not be able to perform this properly, and water will be able to leak from the poor connection. This OEM part is sold individually, so make sure you order the quantity that is needed. The washer measures 1 1/16 inches x 5/8 inches.

This part works with the following brands: Kenmore, Whirlpool, KitchenAid, Roper, Estate, Maytag, Inglis, Crosley, Amana, Admiral, Magic Chef.

This part works with the following products: Washer, Refrigerator, Washer Dryer Combo, Dryer, Dishwasher, Dehumidifier, Freezer, Ice Maker, Air Conditioner.

This part fixes the following symptoms:

  • Leaking.

Compare At

$3.60

You Save

$.60

Your Price

$3.00
Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 1 reviews What's this?
1-1 of 1
 

9 of 23 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 1- 2 hours
Tools: Pliers, Screw drivers, Socket set, Wrench set
Customer: Jerome from Wichita Falls, TX

Cold water slow to fill tub

I started by shutting off the hot/cold water and unplugging the washer...from there, the back panel(secured with approx. eight bolts) was removed; it proved to be the project's most difficult task. The inlet valve was very easy to remove: removed a couple bolts that secured it to the back panel, disconnected the two electrical plugs and water fill hose. The new valve was installed by reversing the above steps; take note to follow the supplied directions as the electrical plugs must go on the valve in a prescribed manner. The back panel actually goes on easier than it comes off. When reinstalling back panel, be sure the water diverter is properly positioned before securing back panel. The diverter can be seen by opening the washer's lid...it's the plastic thing that channels water into the tub. After reassembly, new water supply hoses and washer were installed, moved washer back into place, plugged it in and all worked like new.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1