Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11738530
This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
When the gaskets arrived, in only two days, we unpacked them and layed them out overnight to allow them to come to room temp. The next day I emptyed the frig while my son took out the 20 or so screws around the door. We then layed the door panel on the living room floor pulled off the old gasket replaced the new, lined up the panel and replaced the screws. We did have to put blue painters tape on the doors until the gaskets seated. We suggest this might be included with the directions. This was a very easy DIY project. I belive it will ad years of service to the frig. After all it's cheeper to maintain and repair than to replace.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I removed about 25 nuts from the door which held the inside panel in place. Then I removed the old gasket and placed the new one, making sure it was fitting correctly. I replaced the 25 nuts and the door was ready to go. I had to tape the door shut for a couple days so the new gasket could wear in. It took about 15 min.
only problem was many screws -- like 30 or so -- took a while to get off without a socket wrench and then get back on -- all while the freezer was dripping. Had to do it over a period of time.
Once I received the seal/gasket I put it in the dryer on low for 10 mins ( as advised) then I turn the freezer down to 0 and placed a towel over the food to keep it cool. Although the original gasket had rubber with holes to hold the gasket in place the replacement didn't so I found that I had to make sure the gasket was firmly in place while I put the screws back in place. It took an hour or so because I put them in one corner at a time and then tighten them down. I'm swf in my 50s and I did it so anyone can. Also I have long finger nails and still able to do the repair although I drop a few things
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.