Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/Maytag/12005.gif
See part 5 in the diagram
http://www.partselect.com/Schematics/Maytag/12005.gif

Ice Dispenser Limit Switch

PartSelect Number PS11738246

This ice dispenser limit switch is an in and a half long.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$25.21

You Save

$4.20

Your Price

$21.01
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.7 / 5.0, 3 reviews What's this?
1-3 of 3
 

18 of 38 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 1- 2 hours
Tools: Nutdriver, Pliers, Screw drivers, Wrench set
Customer: MICHAEL from WHITEFIELD, ME

Water dispenser

I put in all new limit switchs. and put in a new water&icemaker valve. now it works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 7 people found this instruction helpful

Parts Used:
  • Ice Dispenser Limit Switch
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Pablo from Whittier, CA

Ice/water switch burned out

The ice maker and water dispenser alway stayed on running it would not shut off automaticlly. i had to shut the power, so i took the front pannel ot were you put the cup in and notice the switch the pushes in and out did not go out it was on the pushed in and the clips were they are pluged inwere burned out so i took the switch off and lokked it up on this site and found exaccly what i needed.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

2 of 3 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: Michael from Kutztown, PA

Ice dispense would stick in on position

Remove the slide-in tray. Remove just the 2 bottom screws of the panel, and slide the panel up to release the top. While suporting the panel, unplug the cable that goes to the PC board in the panel. Remove 3 screws that hold the assembly with ice and water dispenser actuator pad and switch and pull down and out. ( make note how the water tupe is routed for re-assembly) While supporting the assembly disconnect the 2 cables to the assembly. Replace the switch and actuator pad and reassemble. ( make sure the water tube is in the correct position).

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-3 of 3