Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/Frigidaire/MOHEIM5W.gif
See part F37 in the diagram
http://www.partselect.com/Schematics/Frigidaire/MOHEIM5W.gif

PROBE,OVEN TEMP

PartSelect Number PS11731755

The temperature sensor measures approximately 9 inches long. It sends the temperature up to the electronic control. Over time this can become weak and might be sending the wrong temperature signal. If you notice that your oven is not producing enough heat, it could be because the sensor has failed. This part is located at the back of the oven, and is held in place by a few screws and a wire harness. These will need to be removed. The sensor can be slid out from the hole. The new one simply slides into place.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, KENMORE®, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Oven is too hot.
  • Little to no heat when baking.
  • Oven not heating evenly.

Compare At

$38.05

You Save

$6.34

Your Price

$31.71
Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 4 reviews What's this?
1-4 of 4
 

46 of 120 people found this instruction helpful

Parts Used:
  • PROBE,OVEN TEMP
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver
Customer: john from spring, TX

Oven temp not consistent with setting

took off back cover and unplugged old unit and installed new unit. oven probe was not the issue. probally control panel malfunction of readings. will continue using oven temperatue gauge inside to get settings for temperture as temp is important for baking.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

6 of 7 people found this instruction helpful

Parts Used:
  • PROBE,OVEN TEMP
Level of Difficulty: Very Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Michael J from STATEN ISLAND, NY

Trouble code f10 low oven temperature, oven not overheating,low resistance reading on ohm meter

Turned off electric,removed rear panel and replaced part.oven is now operating good as new.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 5 people found this instruction helpful

Parts Used:
  • PROBE,OVEN TEMP
Level of Difficulty: Very Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver
Customer: George from TURNERSVILLE, NJ

Range would start beeping and needed to be unplugged.

Remove 4 screws on back panel. Unclip wire connector and remove probe and install new probe.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

2 of 4 people found this instruction helpful

Parts Used:
  • PROBE,OVEN TEMP
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Socket set
Customer: Tim from ASHAWAY, RI

Oven did not heat up

Replaced the probe because that's what this site recommended.The oven still does not heat up.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-4 of 4