Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11721808
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
replaced pump to tub inlet hose.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Lay the drain pipe lower than the tub to remove any excess water in the tub and lines. Loosened clamp on the tub side with a screwdriver then removed hose from the tub. I used pliers to pinch clamp and remove hose from pump. To install hose put clamps on hose then mount to the pump and the tub then tighten clamps.
turned washer on it side took bottom off removed hose and replaced it with the new one. so very happy i tried it , works great like before. thanks for the easy to find diagram of parts.
Steps:1.- Open the front panel by pressing down (with a spatula) the 2 metal locks located between the front and top panels.2.- Remove the drain hose located int the lower right and at the bottom using a set of pliers and a nutdriver.3.-Install the new drain hose.4.-Reinstall the front panelThe installation itself took me less tha 15 minutes.Since I had opened the the front panel, I took rthe oportunity to air clean and dust off the equipment.
I pulled the front off of the washing machine using a table knife to pop the clips. The drain hose had a hole big enough to put your finger in so we knew that was the problem. One of the clamps holding it on took a screwdriver to loosen the clamp, the other I used a pair of adjustable pliers to squeeze the ends together to loosen it. I pulled off the old part, ordered it, got it the next day and replaced it the same way I took it off. It was simple and the part was less than $10.
first I filled the washer max load to determine the problem, once I saw where the water was dripping I decided to remove the hose. I removed bottom of the hose, and the water from the tank started pouring out, I tryed to put the hose back on but started to get a pretty good electric shock, I then unpluged the washer and ran to garage for the floor squeegy. I then pushed the water out the side door. After cleaning and drying all rooms I sat down at the computer and ordered part. When the part arrived I removed clamp with pliers put both clamps on the new hose and installed. A very simple project and I ended up with a clean laundry room. Thanks "Brainy"
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.