http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/YE1O6B4B.gif
See part 8 in the diagram
http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/YE1O6B4B.gif

Upper Dishrack

PartSelect Number PS11699803

Dishrack ONLY. Wheels NOT included,

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $263.24
  • You Save

    $43.87
  • Your Price

    $219.37
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 12 reviews What's this?
1-5 of 12
 

40 of 68 people found this instruction helpful

Parts Used

  • Upper Dishrack

Level of DifficultyReally Easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDennis from Littleton, CO

Tines were broken and rack was damaged

Replaced the dish rack.

Removed the retaining clips on the front of the rail and removed the old rack.

Removed the spray arm assembly from the old rack.

Assembled the new rack, with the supplied parts from the kit. Using the old rack to know where some parts needed to be placed.

Put the spray arm assembly on the new rack.

Inserted the new rack into the rails

Replaced retaining clips.

Help other customers find the most helpful instructions.

Were these instructions helpful?

19 of 31 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

Tools

CustomerAnthony from Highland Lakes, NJ

Replaced upper and lower racks

Easy. only one little trouble spot. but very easy " repair" for the lower rack. take out of box. place in dishwasher. pull old center spindle part off by twisting 90 degrees and put into new rack same way. When replacing the top rack. keep the old one in one piece till you put together the new one. mine didn't come with any instructions. pretty simple anyway. but no problem when you can use your old one as a guide. once you put it together the only hard part i had was right at the end.. figures right!! last piece.. but to snap back in the center unit the spins around into the new one took alot of force. but it went. thats it...

Help other customers find the most helpful instructions.

Were these instructions helpful?

18 of 38 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers

CustomerAllen from Jacksonville, NC

Replaced old dish racks that had rusted and had broken tines.

Took the old wheels, and other parts from the old racks and installed them on the new. The wheels on the lower rack just snap on. Also the folding tines just snapped on. On the upper rack the brackets that hold the wheels have two screws that hold the bracket. I removed them and then installed the bracket on the new rack in the same position as on the old one. The only hard part was getting the old spray arm off the old rack. I had no directions so I had to figure it out for myself. I finally cut the the old rack to get the pressure tower off. It was stuck because of having been in place for more than ten years. Putting the tower and the arm on the new rack was no problem once I had it removed. Total time to do the job about 45 minutes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

10 of 22 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers

Customergary from Tillamook, OR

Rusted racks

Repair went OK but there were no instructions at all. Just boxes full of parts. Otherwise,assembly went smoothly. The dishwasher works like new. ( I feel that the parts were way over priced)

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 17 people found this instruction helpful

Parts Used

  • Upper Dishrack

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

Tools

CustomerRobert from Indianapolis, IN

The dividers were breaking off the top rack of our dishwasher. Order new rack and installed in minutes. Works great.

Took out old rack by twisting the rack supports. Used old supports because in good shape. Removed the wand from old rack and placed on new rack. Then replaced the supports. Worked great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-5 of 12