Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS1155189
This part works with the following brands: GE, Hotpoint & Kenmore.
First, had to use punch tool to pop out electronic face panel. Face unit still connnect via wires. Use painters tape to hold against refrig. Next, Remove ice/water dispenser and also tape to door. This will give you access to solenoid. Remove the 3 screws holding it in place and unplug fsolenoid from Face Panel. Screw new solenoid and place and connnect to Panel. Goood idea is to unplug regrig. while doing this and put a little WD-30 on shaft of solenoid. May want to order new screws, could be rusty, that hold solenoid in place. Sounds a bit complicated but not that bad a job. You'll save over$100 over GE's service.
Help other customers find the most helpful instructions.
Were these instructions helpful?
removed the depenser or ice collecter disassyble,replace the new auger and install the collecter tray in freezer.the bulbs i got was for use as i needed,at a later date i have not been able to fine the ice and water depenser bulbs on the open market.
kick plate replacement at the base of refrigerator. Very easy to replace. No rocket science needed :)
Just had to pull ice maker drawer out and replace the drive cup which was very simple. Light bulb on door dispenser was kind of hard to get back in cause it is such a small space to screw the bulb in.
Pretty easy to repair. Only took a few minutes.
Removed front panel (using small screw driver) by popping it out, disconnected wire from solenoid, removed solenoid which was rusted, 3 small philip head screws held it in place insereted new solenoid,connected wire snapped front panel back in. Clapper valve closes tightly and no frost in frezzer, saved my self a bunch of money.
found the correct bulbs, the hardest part.un screwed old bulb.Screwed in new bulb.Waa La,There was light.
unscrewed lamp and replaced it with new one!
remove old bulb by screwing it out/install new bulb by screwing it in.
My water filter was a breeze to install. Just push up and to the right and it locks right in. As for the Water Dispenser light. Just screw it in!!
Used awl inserted into 3 holes at bottom of dispenser toutch pad #93 to release it from mount. Disconnected wire to solenoid & rested panel in door opening. Removed 4 screws holding dispensor housing shield #69. Removed 3 screws holding solenoid & connecting arm #36. Solenoid very rusted. Cleaned inside of ice dispensor with bleach to remove crud & mold. Installed solenoid & reassembled shield & touch pad. Replaced light bulb in dispenser. Flapper now closes tight, problem solved.
Simple straight forward process. Remove the refrigerator back cover, unhook the inlet water lines and replace water valve.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.