1155105-1-S-GE-WH13X10024        -Dual Water Inlet Valve
1155105-1-S-GE-WH13X10024        -Dual Water Inlet Valve 1155105-2-S-GE-WH13X10024        -Dual Water Inlet Valve 1155105-3-S-GE-WH13X10024        -Dual Water Inlet Valve

Dual Water Inlet Valve

PartSelect Number PS1155105

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Will not stop filling with water.
  • Leaking water.
  • No hot or cold water.
  • Will not fill with water.
  • Compare At

    $48.61
  • You Save

    $8.10
  • Your Price

    $40.51
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.5 / 5.0, 33 reviews What's this?
31-33 of 33
 

0 of 1 people found this instruction helpful

Parts Used

  • Dual Water Inlet Valve

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver, Socket set

CustomerWilliam from Bend Oregon OR

Frozen water input valve

removed screws from control panel. pulled panel back to reach control valve and removed two screws holding valve. found that freezing caused one valve to leak. pushed valve back and reinstalled. That did not work so ordered a new valve, installed it and all worked find. don't forget to unplug washer from electricity and turn off water supply. Also the garage
floor needs water spill removed asap as the water froze on me and made it difficult to remove.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Dual Water Inlet Valve

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsSocket set

CustomerRachel from Charlotte NC

Washing machine was leaking cold water

I removed the four screws at the top of the washing machine and pulled the front cover off. I unscrewed the two screws that was holding the valve and disconnected the sockets. Last put on the part and connected two wires and put screws back in and reconnected the hoses and washing machine is working perfectly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 7 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerMilton from Riverview FL

Cold water would continue to run and over flow from washer

1. Removed 2 knobs
2. Removed 4 screws from the top of front panel and opened
3. Disconnected a small hose and two electrical connection and removed the Water level pressure switch
4. Replaced switch in reverse order
5. Disconnected hot/cold water hoses, removed three screws and four electrical connectors and removed water valve (Valve water)
6. Replaced valve in reverse order
7. Reinstalled front panel with 4 screws and reinstalled two knobs.

Help other customers find the most helpful instructions.

Were these instructions helpful?

31-33 of 33