1155104-1-S-GE-WH12X10323        -Control Assembly
1155104-1-S-GE-WH12X10323        -Control Assembly 1155104-2-S-GE-WH12X10323        -Control Assembly 1155104-3-S-GE-WH12X10323        -Control Assembly

Control Assembly

PartSelect Number PS1155104

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Will Not Start.
  • Timer will not advance.
  • Compare At

    $177.35
  • You Save

    $29.56
  • Your Price

    $147.79
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.6 / 5.0, 3 reviews What's this?
1-3 of 3
 

17 of 20 people found this instruction helpful

Parts Used

  • Control Assembly

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerJohn from Adams MA

Washer kept turning off during cycles

First remove the control knobs by pulling them straight off. then remove the screws on the top of the washer control panel and flip the whole assembly forward. remove the electrical connectors(two) and the jumper connector as the new control does not come with one. remove the screws holding the control unit down and remove it. Install the new unit and plug in the two electrical connectors and the jumper connector. flip the unit back up and install the scews on the top. push the knobs back on and you are done

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 4 people found this instruction helpful

Parts Used

  • Control Assembly

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsSocket set

CustomerRYAN from Monterey CA

Knob snapped off during move

Removed all knobs for washer settings; Unscrewed the hex screws on top of washer panel, then used socket wrench to take screws off; replaced the part with a good one and it worked just fine. Funny how a broken-off 1/4" piece of plastic can cost $100...only way to repair this though. GE was going to charge $224 to do a 15-minute repair and all it cost me was 15 minutes of my time.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

  • Control Assembly

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

Tools

CustomerRussell from Chattaroy WA

Shut down in middle of cycle, bad switch on cycle selector

removed 4 screws from top of control console
lowered and turned over console
removed 6 screws holding control assembly
removed 2 electrical connectors and 1 jumper connector
reverse to install

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3