Quick Question!

Have you ever purchased from PartSelect.com before?

1148773-1-S-Frigidaire-134515300         -Bellow Kit
1148773-1-S-Frigidaire-134515300         -Bellow Kit 1148773-2-S-Frigidaire-134515300         -Bellow Kit 1148773-3-S-Frigidaire-134515300         -Bellow Kit http://www.partselect.com/Schematics/Frigidaire/HZVQ2R9M.gif

Bellow Kit

PartSelect Number PS1148773

Manufacturer Part Number 134515300
Manufactured by Frigidaire

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle. NOTE: This part has been redesigned by the manufacturer and is interchangeable with the old design.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Leaking.
  • Marks left on clothes.

Compare At


You Save


Your Price

Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 1 reviews What's this?
1-1 of 1

212 of 291 people found this instruction helpful

Parts Used:
  • Bellow Kit
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Screw drivers
Customer: Peggy from New Castle, PA

Old bellow ripped

remove top of machine by removing 3 screws along the top edge in the back of your machine and then sliding the top back and up. Then loosen the screws holding on the control panel enough to get to the 2 screws at the top of the door panel. Next remove bottom panel by removing 2 screws along bottom edge then pulling it free from snaps. Then along the outside lip of the bellow, just inside the door, is a wire clip that is easily removed by prying it past rubber lip with a screw driver and lifting it away. Remove the door panel by removing the 2 screws you exposed by loosening the control panel and 2 more along the bottom that were exposed when removing bottom panel. After the door panel is removed and the bellow is completely exposed, you will find that it is held in place by a circular spring which wraps the whole way around the drum opening. Again it can be removed by prying it out away from the groove in which it sits with a screw driver. Now your machine is broken down as far as it needs to be. From here you can follow the directions included in your new bellow kit and put it back together by following these instructions in reverse.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1