Quick Question!

Have you ever purchased from PartSelect.com before?

1145940-1-S-Frigidaire-134523200         -Control Board with Housing
1145940-1-S-Frigidaire-134523200         -Control Board with Housing 1145940-2-S-Frigidaire-134523200         -Control Board with Housing http://www.partselect.com/Schematics/Frigidaire/0BE59HB1.gif

Control Board with Housing

PartSelect Number PS1145940

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Will Not Start.

Compare At

$291.08

You Save

$48.51

Your Price

$242.57
Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

32 of 46 people found this instruction helpful

Parts Used:
  • Control Board with Housing
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Thomas from Mauldin, SC

White magic smoke came out of front.

I removed two screws at the rear top, slid the top back. Then removed the screws holding the front face on. The circut board had a few screws holding it on. I removed them and detachted the wires, then installed the new board. I then reassembled the front and the wires. I put it back together and plugged it in. Everything lit up and the dryer was fixed. HORRAY! My wife was happy again. Daddy saves the day, not to mention the repair cost.!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

2 of 2 people found this instruction helpful

Parts Used:
  • Control Board with Housing
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Screw drivers
Customer: James from St. Augustine, FL

Remove and replace electronic control board

It's easy. Make sure the dryer is unplugged, or the circuit breaker is open. Remove the two screws at back of top panel, and slide the panel rearwards to remove it from the dryer, and set it aside. Remove the four screws that secure the interface panel/control board assembly to the dryer. Unplug the wire harnesses from the back of the control board, making note of the position of red and black terminal lugs. Lay the assembly front-side-down on a soft surface, and remove the six screws attaching the control board to the interface panel. Once the screws are removed, carefully pry open the plastic locking tabs to allow the control board and interface panel to separate. The cycle knob and its shaft are tight fitting, so be careful while prying them apart. Transfer the clear plastic light tubes, and the digital display module, from the old control board to the new one, then the cycle knob and its shaft, making sure to align the slots. Carefully press the new control board into position on the interface panel until the plastic tabs lock it in place. Then re-install the screws. At the dryer, re-attach the wiring harnesses, making sure to return the red and black wires to their correct position. Secure the assembly to the dryer with the four screws, making sure that no wires are pinched or chaffing against metal surfaces. Slide the top panel back into position (from back to front) so that it seats properly, and re-install the two screws to secure it. Re-attach the vent duct if necessary, close the breaker or plug the machine in, and you should be good to go!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2