| |
17 of 23 people found this instruction helpful
Parts Used
-
- Water Inlet and Dispenser Valve
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers, Socket set
CustomerJulie from Lancaster OH
Valve dispener would spray water all over inside of washer.
My husband made the repair. First, he had to remove the dryer off of the top of the washer since it's a stacking unit. Disconnect water lines. Next he removed two screws from the back of the washer that allows you to remove the lid. Now unsnap a trim piece that is on the back surrounding the water connections and an exhaust port. Reach inside the washer, turn the exhaust port unlocking it and pushing out the back of the washer as far as you can to get it out of the way. Disconnect the electrical lines from the valve dispenser. Remove the two screws that fasten the valve dispenser to the washer. Install the new dispenser and reassemble.
|
5 of 9 people found this instruction helpful
Parts Used
-
- Water Inlet and Dispenser Valve
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerGeorge from INMAN SC
I had tried to clean the small basket type screens at the rear of the inlet valve but both of them disintegrated
Following the instructions on your page I was able to see quite clearly what needed to be done. I received the new part promptly and my machine is now working fine. However, the ongoing story with the dryer is another matter.
|
3 of 6 people found this instruction helpful
Parts Used
-
- Water Inlet and Dispenser Valve
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerFrank from Auburn NH
Frozen pipe
Removed top cover to get access to intake pipe for hot & cold water. Remove electrical connections and two screws replaced part and cover. Thanks very quick service.
|